Delta VFD300C43S-HS User Manual page 300

Chapter 12 Description of Parameter SettingsC2000-HS
Input Terminal of I/O Extension Card (MI14)
Input Terminal of I/O Extension Card (MI15)
Settings
0: No function
1: Multi-step speed command 1 / multi-step position command 1
2: Multi-step speed command 2 / multi-step position command 2
3: Multi-step speed command 3 / multi-step position command 3
4: Multi-step speed command 4 / multi-step position command 4
5: Reset
6: JOG command (By KPC-CC01 or external control)
7: Acceleration / deceleration speed inhibit
8: 1 st
9: 3
rd
10: EF Input (Pr. 07-20)
11: B.B input from external (Base Block)
12: Output stop
13: Cancel the setting of auto-acceleration / auto-deceleration time
14: Switch between motor 1 and motor 2
15: Rotating speed command from AVI
16: Rotating speed command from ACI
17: Rotating speed command from AUI
18: Forced to stop (Pr. 07-20)
19: Digital up command
20: Digital down command
21: PID function disabled
22: Clear the counter
23: Input the counter value (MI6)
24: FWD JOG command
25: REV JOG command
26: TQC / FOC mode selection
27: ASR1 / ASR2 selection
28: Emergency stop (EF1)
29: Signal confirmation for Y-connection
30: Signal confirmation for -connection
31: High torque bias (Pr. 11-30)
32: Middle torque bias (Pr. 11-31)
33: Low torque bias (Pr. 11-32)
34: Switch between multi-step position and multi-step speed control
35: Enable single-point position control
36: Enable multi-step position learning function (valid at stop)
and 2 nd acceleration / deceleration time selection
and 4 acceleration / deceleration time selection
th
12.1-02-2
Default: 0