Delta VFD300C43S-HS User Manual page 447

I/F Mode, Id Current Low Pass-Filter Time

Settings

Sets the filter time for Pr. 10-31. Smoothly increases the magnetic field to the current command
setting value under the I/F mode.

If you want to slowly increase the size of Id, increase the filter time to avoid a Step phenomenon
occurs when starting current output. When decrease the filter time (minimum value is 0), the
current rises faster, then a Step phenomenon occurs.
Initial Angle Detection Pulse Value

Settings
 The angle detection is fixed to 3: Use the pulse injection method to start. The parameter
influences the value of the pulse during the angle detection. The larger the pulse, the higher the
accuracy of rotator's position. A larger pulse might cause oc.
 Increase the parameter when the running direction and the command are opposite during
start-up. If oc occurs at start-up, then decrease the parameter.
 Refer to Section 12-2 Adjustment & Application for detailed motor adjustment procedure.
PG Card Version
Settings

Corresponding version reference:
 Zero Voltage Time during Start-up
Settings
 This parameter is valid only when the setting of Pr. 07-12 (Speed Tracking during Start-up) = 0.
 When the motor is in static status at start-up, this increases the accuracy when estimating
angles. In order to put the motor in static state, set the three-phase drive output to 0 V to the
motor. The Pr. 10-49 setting time is the length of time when three-phase output at 0 V.
 It is possible that even when you apply this parameter, the motor cannot go into the static state
because of inertia or some external force. If the motor does not go into the static state in 0.2
seconds, increase this setting value appropriately.
 If Pr. 10-49 is too high, the start-up time is longer. If it is too low, then the braking performance is
weak.
 Reverse Angle Limit (Electrical Angle)
Settings
0.0–6.0 sec.
0.0–3.0
0–655.35
PG02U
PG01U
PG01O / PG01L
PG02O / PG02L
PG01R
0.000–60.000 sec.
0.00–30.00 degree
Chapter 12 Description of Parameter SettingsC2000-HS
21.XX
31.XX
11.XX
14.XX
41.XX
12.1-10-10
Default: 0.2
Default: 1.0
Default: Read only
Default: 0.000
Default: 10.00