Delta VFD300C43S-HS User Manual page 326

Chapter 12 Description of Parameter SettingsC2000-HS
 When the drive outputs current higher than the setting for Pr. 02-33 Pivot Point of the Current (≥
Pr. 02-33), and outputs frequency higher than the setting for Pr. 02-34 Pivot Point of the
Frequency (≥ Pr. 02-34), multi-function output Pr. 02-13, Pr. 02-14, Pr. 02-16 and Pr. 02-17 are
set to 42 after the delay time setting for Pr. 02-32.
 When the Pivot Point of the Current 's setting Pr. 02-57≠0 and when the output current of the
drive is lower than the setting for Pr. 02-57 (< Pr. 02-57), or the output frequency is lower than
the setting for Pr.02-58 (< Pr. 02-58), disable the setting #42 of the multi-function output Pr.
02-13, Pr. 02-14, Pr. 02-16 and Pr. 02-17.
 When Pr. 02-57 = 0, the output current is lower than the setting for Pr. 02-33 Pivot Point of the
current (< Pr. 02-33), or the output frequency is lower than the setting for Pr. 02-58(< Pr. 02-58),
disable the setting of #42 of the multi-function output Pr. 02-13, Pr. 02-14, Pr. 02-16 and Pr.
02-17.
 When using crane application, and MOx=42, Pr. 02-34 must be larger than Pr. 02-58; and Pr.
02-33 must be larger than Pr. 02-57.
Frequency Reached Detection Amplitude
Settings
 The upper limit of setting range is the same as the maximum operating frequency for Pr. 01-00.
IO Card Types
Settings
DFM Output Selection
Settings
Internal / External Multi-function Input Terminal Selection
Settings
 Selects the terminals MI1–MI15 to be internal terminals or external terminals. When the MIx is set
as internal terminal, the corresponding external terminal function is disabled.
 To activate internal terminals via Pr. 02-75 setting.
0.0–1500.0 Hz
Read only
1: EMC-BPS01
4: EMC-D611A
5: EMC-D42A
6: EMC-R6AA
11: EMC-A22A
0: Use frequency with speed control as DFM output frequency
1: Use frequency with system acceleration / deceleration as DFM output
frequency
0000–FFFFh
12.1-02-28
Default: 0.0
Default: Read only
Default: 0
Default: 0000h