Delta VFD300C43S-HS User Manual page 468

Chapter 12 Description of Parameter SettingsC2000-HS
0–10 V or 4–20 mA. At this moment, Pr.14-10 and Pr.14-11 are invalid.
 Setting 1 or 2: Displays the warning code "ANL" on the keypad. It continues blinking until the
lost ACI signal is recovered.
 When the motor drive stops, the warning condition does not continue to exist, so the warning
disappears.
 Extension Card Output Terminal Selection (AO10)
 Extension Card Output Terminal Selection (AO11)
Settings
 Refer to the function chart below for details setting.
Function Chart
Settings Functions
0 Output frequency (Hz)
1 Frequency command (Hz) Maximum frequency Pr.01-00 is processed as 100%.
2 Motor speed (Hz)
3 Output current (rms)
4 Output voltage
5 DC BUS voltage
6 Power factor
7 Power
8 Torque
9 AVI
10 ACI
11 AUI
12 Iq current command
13 Iq feedback value
14 Id current command
15 Id feedback value
18 Torque command
19 PG2 frequency command Maximum frequency Pr.01-00 is processed as 100%.
20 CANopen analog output
21 RS-485 analog output
Communication card
22
analog output
23 Constant voltage output
CANopen and RS-485
25
analog output
0–23
Maximum frequency Pr.01-00 is processed as 100%.
Maximum frequency Pr.01-00 is processed as 100%.
(2.5 ᵡ rated current) is processed as 100%
(2 ᵡ rated voltage) is processed as 100%
450V (900V)=100%
-1.000–1.000=100%
(2 ᵡ rated power) is processed as 100%
Full load torque = 100%
0–10 V = 0–100%
4–20 mA = 0–100%
-10–10V = 0–100%
(2.5 ᵡ rated current) is processed as 100%
(2.5 ᵡ rated current) is processed as 100%
(2.5 ᵡ rated current) is processed as 100%
(2.5 ᵡ rated current) is processed as 100%
Rated torque of motor = 100%
For CANopen communication analog output
For RS-485 (InnerCOM / MODBUS) analog output
For communication analog output (CMC-MOD01, CMC-EIP01,
CMC-PN01, CMC-DN01)
Pr.03-32 controls the voltage output level.
0–100% of Pr.03-32 corresponds to 0–10V of AFM.
For CANopen and InnerCOM control output
12.1-14-2
Default: 0
Descriptions