Delta VFD300C43S-HS User Manual page 243

Pr. Parameter Name
Electronic thermal relay selection
06-13

1 (Motor 1)
Electronic thermal relay action
06-14

time 1 (Motor 1)
Temperature level over-heat (OH)
06-15

warning
Stall prevention limit level
06-16 (Weak magnetic area current stall

prevention level)
Fault record 1
06-17
(Present fault record)
06-18 Fault record 2
06-19 Fault record 3
06-20 Fault record 4
06-21 Fault record 5
06-22 Fault record 6
Chapter 11 Summary of Parameter SettingsC2000-HS
Setting Range
0: Inverter motor (with external forced cooling)
1: Standard motor (motor with fan on the shaft)
2: Disable
30.0–600.0 sec.
0.0–110.0°C
0–100% (Pr. 06-03, Pr. 06-04)
0: No fault record
1: Over-current during acceleration (ocA)
2: Over-current during deceleration (ocd)
3: Over-current during constant speed (ocn)
4: Ground fault (GFF)
5: IGBT short-circuit (occ)
6: Over-current at stop (ocS)
7: Over-voltage during acceleration (ovA)
8: Over-voltage during deceleration (ovd)
9: Over-voltage during constant speed (ovn)
10: Over-voltage at stop (ovS)
11: Low-voltage during acceleration (LvA)
12: Low-voltage during deceleration (Lvd)
13: Low-voltage during constant speed (Lvn)
14: Low-voltage at stop (LvS)
15: Phase loss protection (OrP)
16: IGBT over-heat (oH1)
17: Capacitance over-heat (oH2)
18: TH1 open: IGBT over-heat protection error (tH1o)
19: TH2 open: capacitance over-heat protection error
(tH2o)
21: Drive over-load (oL)
22: Electronics thermal relay protection 1 (EoL1)
23: Electronics thermal relay protection 2 (EoL2)
24: Motor overheat (oH3) (PTC / PT100)
26: Over-torque 1 (ot1)
27: Over-torque 2 (ot2)
28: Low current (uC)
29: Home limit error (LMIT)
30: Memory write-in error (cF1)
11-27
Default
2
60.0
105.0
100
0
0
0
0
0
0