Set Tv Line Number For Synchronization - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
TRIGger Subsystem

Set TV Line Number for Synchronization

:TRIGger[:SEQuence]:TV:LINE <line>
:TRIGger[:SEQuence]:TV:LINE?
This command allows you to set the TV line number to which the analyzer will
synchronize its sweep. Requires Option BAA and B7B.
Factory Preset
and *RST: 17
Range: The range is dependent upon the Field Mode, as described in the
command : TRIGger[:SEQuence]:TV:FMODe
ENTire|ODD|EVEN : The minimum value is the minimum
line, and rolls over to the maximum value. The maximum value
is the maximum line, and rolls over to the minimum value.
History: Added TV trigger mode with firmware revision A.03.00.
Remarks: Refer to the command :TRIGger[:SEQuence]:SOURce:TV,
which is used to activate TV triggering.
Set Analyzer for TV Picture Monitoring
:TRIGger[:SEQuence]:TV:MONitor OFF|ON|0|1
:TRIGger[:SEQuence]:TV:MONitor?
The currently-selected standard is used to determine the proper setup of the
hardware state of the video digitization circuitry for presentation of the TV picture.
Requires Option BAA and B7B.
Factory Preset
and *RST: Off
History: Added TV trigger mode with firmware revision A.03.00.
Front Panel
Access: Trig, TV Trig Setup, TV Monitor
Set the Video Waveform Sync. Pulse Direction
:TRIGger[:SEQuence]:TV:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:TV:SLOPe?
This command defines the direction of the sync pulse on the TV video waveform.
Normal baseband video has sync pulses on the bottom of the waveform (use the
NEG parameter for more negative voltage). However, when the analyzer is used to
demodulate an NTSC or PAL TV RF carrier, the detected video waveform is
"upside down" with sync pulses on the top of the waveform (use the
386
POS
Chapter 5