Single - Agilent Technologies ESA Series User's/Programmer's Reference

Front-Panel Key Reference

Single

Single
When analyzer is in continuous sweep mode and not in a measurement
( , ), this key changes the sweep control to single sweep
Measure Meas Off
and executes a sweep after the trigger condition is met. If the analyzer
is already in single sweep, pressing executes a new sweep after
Single
the trigger condition is met.
If Average is on ( , ), pressing resets the
BW/Avg Average (On) Single
average trace and starts the average again from a count of zero. Sweeps
are averaged until N sweeps are then taken (where N is the average
number), and then the sweep is halted.
Some one-button measurements require more than one sweep to
complete the measurement. The measurements selected from the
functions under the key set the trigger system to be initiated
MEASURE
only once. In this case the trigger condition can be met only once and
then all the necessary sweeps will be executed to make the
measurement.
Chapter 2 133