Define Peak Search - Agilent Technologies ESA Series User's/Programmer's Reference

Define Peak Search

:CALCulate:MARKer:PEAK:SEARch:MODE PARameter|MAXimum
:CALCulate:MARKer:PEAK:SEARch:MODE?
Sets the peak search mode.
Factory Preset
and *RST:
Remarks:
Front Panel
Access:
Define Peak Threshold
:CALCulate:MARKer:PEAK:THReshold <ampl>
:CALCulate:MARKer:PEAK:THReshold?
Specifies the minimum signal level for the analyzers internal peak identification
routine to recognize a signal as a peak. This applies to all traces and all windows.
See command :CALCulate:MARKer:PEAK:SEARch:MODE
NOTE
Range:
Default Unit:
Front Panel
Access:
Peak to Peak Delta Markers
:CALCulate:MARKer[1]|2|3|4:PTPeak
Positions delta markers on the highest and lowest points on the trace.
Chapter 5
MAXimum
If mode is set to MAXimum, peak search will place the marker
at the maximum amplitude in the trace. If mode is set to
PARameter, peak search will place the marker at the highest
peak that rises and falls by at least the peak excursion above the
peak threshold. If no peak meets the excursion and threshold
criteria, a No Peak Found error (error 202) is issued.
Next peak, next peak right, next peak left, and peak table are not
affected by this command. They will always use peak excursion
and peak threshold for search criteria.
Peak Search (or Search), Search Criteria, Peak Search
Type, Max Value|Excursion & Threshold
Reference level to the bottom of the display
Amplitude units
Peak Search (or Search), Search Criteria, Peak Threshold
Remote Command Reference
CALCulate:MARKer Subsection
255