Immediate Auto-Range Emi Detector - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
[:SENSe]:DETector Subsection
Front Panel
Access: Det/Demod

Immediate Auto-Range EMI Detector

[:SENSe]:DETector:RANGe:IMMediate
Re-runs the amplitude ranging process. This optimizes the available dynamic
range for measurements using the EMI quasi-peak and average detectors. See also
SENSe:DETector:FUNCtion:EMI .
Remarks: This command is only available with Option AYQ installed.
History: Added with firmware revision A.14.00.
Auto-Range EMI Detector
[:SENSe]:DETector:RANGe[:STATe] OFF|N|0|1
[:SENSe]:DETector:RANGe[:STATe]?
Turns on/off the amplitude ranging process. This process optimizes the available
dynamic range for measurements using the EMI quasi-peak and average detectors
and is usually done automatically each time one of these detector types is selected.
This turns off the auto-ranging behavior. See also
SENSe:DETector:FUNCtion:EMI .
Factory Preset
and *RST: On
Remarks: This command is only available with Option AYQ installed.
History: Added with firmware revision A.14.00.
Remove EMI Auto-Range
[:SENSe]:DETector:UNRange
Returns the instrument settings for reference level and attenuation to the values
they were before the last auto-ranging command was sent. The amplitude
auto-ranging process optimizes the available dynamic range for measurements
using the EMI quasi-peak and average detectors. See
SENSe:DETector:RANGe:IMMediate .
Remarks: This command is only available with Option AYQ installed.
History: Added with firmware revision A.14.00.
322
, EMI Detector
Chapter 5