Questionable Status Integrity Event Condition And Enable Registers - Agilent Technologies ESA Series User's/Programmer's Reference

Status Registers
Use Status Registers to Determine the State of Analyzer Events and Conditions

Questionable Status Integrity Event Condition and Enable Registers

The Questionable Status Integrity Condition Register continuously monitors the calibration status of the
analyzer. Condition registers are read-only. To query the condition register, send the command
:STATus:QUEStionable:INTegrity:CONDition? The response will be the decimal sum of the
bits which are set to 1.
The transition filter specifies which types of bit state changes in the condition register will set
corresponding bits in the event register. The changes may be positive (from 0 to 1) or negative (from 1 to
0). Send the command :STATus:QUEStionable:INTegrity:NTRansition <num> (negative
transition) or :STATus:QUEStionable:INTegrity:PTRansition <num> (positive transition)
where <num> is the sum of the decimal values of the bits you want to enable.
The Questionable Status Integrity Event Register latches transition events from the condition register as
specified by the transition filters. Event registers are destructive read-only. Reading data from an event
register will clear the content of that register. To query the event register, send the command
:STATus:QUEStionable:INTegrity[:EVENt]?
See "Questionable Status Event Enable Register" on page 216
summary bit using the event enable register. In this case, use the command
:STATus:QUEStionable:INTegrity:ENABle <num>.
230
Bit Decimal Description
Value
a 16384 Setting Limited/Readjusted: A 1 in this bit
14
position indicates that the user settings could not be
achieved with the existing hardware; values were set to
limits.
15 32768 Always Zero (0): This bit is always set to 0.
a. This bit applies to ESA optional measurement personalities only, and may or may not
be implemented in all such personalities.
for an explanation of how to set the
Chapter 4