Operation Complete - Agilent Technologies ESA Series User's/Programmer's Reference

The following example is a response to *LRN? The actual sizes will vary depending on
the instrument state data size.
Example:
NOTE The state can be changed by sending this block of data to the instrument after
removing the size information:
Example:

Operation Complete

*OPC
*OPC?
Sets bit 0 in the standard event status register to "1" when all pending operations
have finished.
The query stops any new commands from being processed until the current
processing is complete. Then it returns a "1", and the program continues. This
query can be used to synchronize events of other instruments on the external bus.
*OPC and *OPC? are currently effective only when immediately preceded by either
the : INITiate:IMMediate or a : CALibration command.
Query Instrument Options
This function is provided in the analyzer SCPI language reference in the SYSTem
subsystem under : SYSTem:OPTions? .
Recall
*RCL <register>
This command recalls the instrument state from the specified instrument memory
register.
Range:
Remarks:
Chapter 5
#42031SYST:SET #42016<state data>
The number 4 (P in the preceding query response format) means
there are 4 numbers that make up the size of the data that
follows. In this example, 2031 bytes will follow the number 4
(42031).
2031 and 2016 (QQQ and MMM in the preceding query
response format) represent data size in bytes.
SYST:SET #NMMM<state_data>
Registers are an integer, 0 to 127
See also commands : MMEMory:LOAD:STATe and
Remote Command Reference
IEEE Common Commands
237