Table of Contents
Advertisement
To set the line voltage
When shipped from the factory, the line voltage selector is set and an
appropriate fuse is installed for operating the instrument in the country of
destination. To operate the instrument from a power source other than the
one set, perform the following steps.
Turn the power switch to the Off position, then remove the power
1
cord from the instrument.
Remove the fuse module by carefully prying at the top center of the
2
fuse module until you can grasp it and pull it out by hand.
Reinsert the fuse module with the arrow for the appropriate line
3
voltage aligned with the arrow on the line filter assembly switch.
Operator's Service
To set the line voltage
20-7
Advertisement
Table of Contents
