Trace Math Add - Agilent Technologies ESA Series User's/Programmer's Reference

Front Panel
Access: View/Trace, Operations, 1 <–> 3
View/Trace, Operations, 2 <–> 3

Trace Math Add

:TRACe:MATH:ADD
<destination_trace>,<source_trace1>,<source_trace2>
Adds the magnitudes of the two source traces and places the result in the
destination trace.
Destination traces are: TRACE1|2|3
Source traces are: TRACE1|2|3
Example: :TRAC:MATH:ADD TRACE2,TRACE1,TRACE3 is equivalent
to : (trace 2 = trace 1 + trace 3)
Mean Trace Data
:TRACe:MATH:MEAN? <trace>
Returns the mean of the amplitudes of the trace amplitude elements in
measurement units.
Traces are: TRACE1|2|3
Query the Signal Peaks
:TRACe:MATH:PEAK[:DATA]?
Outputs the signal peaks by frequency or by amplitude. This command uses only
trace1 data. The data is returned as alternating amplitude, frequency pairs.
The sort mode is determined by the command :TRACe:MATH:PEAK:SORT.
The commands :CALCulate:MARKer:PEAK:EXCursion and
:CALCulate:MARKer:PEAK:THReshold are used to determine what is a signal
peak. To get the number of signals found meeting the specified limits, use the
query :TRACe:MATH:PEAK:POINts?
Query Number of Peaks Found
:TRACe:MATH:PEAK:POINts?
Outputs the number of signal peaks identified. The amplitude of the peaks can then
Chapter 5
Remote Command Reference
TRACe Subsystem
375