Trace/View - Agilent Technologies ESA Series User's/Programmer's Reference

Trace/View

Accesses the trace keys that allow you to store and manipulate trace
information. Each trace is comprised of a series of data points in which
amplitude information is stored. The analyzer updates the information
for any active trace with each sweep.
If you have selected
NOTE
Power
menu, refer to the one-button measurement information in Volume 2.
Selects the menu keys used for trace 1, trace 2, or trace 3 functions.
Trace 1 2 3
Press
Key Access:
When using normalization, the mode of traces 2 and 3 should not be
CAUTION
changed.
Erases any data previously stored in the selected trace and
Clear Write
continuously displays any signals during the sweep of the analyzer.
This function is activated for trace 1 at power-on and by pressing
Preset
Key Access:
Maintains the maximum level for each trace point of the selected trace
Max Hold
(1, 2 or 3), and updates each trace point if a new maximum level is
detected in successive sweeps.
If the
NOTE
change with trace mode. See
information.
Key Access:
Changing the vertical scale (
NOTE
Restart
window in Zone Span (
Maintains the minimum level for each trace point of the selected trace
Min Hold
(1, 2 or 3), and updates each trace point if a new minimum level is
detected in successive sweeps.
Key Access:
Chapter 2
Channel Power
, , or
Power Stat CCDF Spectrum Emission Mask
until the number of the desired trace is underlined.
Trace 1 2 3
Trace/View
.
Trace/View
, (Auto) is selected, the detection type may
Det/Demod Detector
Trace/View
, turning averaging on (
,
Span
Trace/View
, ,
ACP Harmonic Distortion
Figure 2-1 on page 57
, , Log or Lin), pressing
Amplitude Scale Type
,
BW/Avg Average (On)
) restarts the held trace.
Zone
Front-Panel Key Reference
Trace/View
,
Burst
in the
MEASURE
for more detailed
), or switching
167