Agilent Technologies ESA Series User's/Programmer's Reference page 76

Front-Panel Key Reference
Display
Delete Limit
Freq Interp
Log Lin
76
Connected to Previous Pt
Yes No
Allows you to determine whether the
current point will be connected to the
previous point. No limit testing is
performed between disconnected
points. Pressing this key when the
Connected field is selected toggles the
Connected value of the current point
and increments the Point number to
allow entry or editing of the Frequency
of the next point. If a Tab key is pressed
without entering a value, the current
Connected value of the point is
selected. If Tab ⇑ is pressed, the Point
number automatically increments to
allow entry of the Connected value of
the next point, or if a new point, to
allow to be entered for the
Frequency
new point.
Key Access: ,
Display Limits
,
Limit 2 Edit
Delete Point
Allows you to delete the current point
in the limit line. You will be prompted
with the message If you are sure,
press key again to delete.
Pressing again will delete
Delete Point
the point.
Key Access: ,
Display Limits
,
Limit 2 Edit
Allows you to delete the current limit
set. You will be prompted with the
message If you are sure, press
key again to delete. Pressing
again will delete the limit set.
Key Access: ,
Display Limits
Limit 2
Allows you to determine how limit
trace values are computed between
points in a limit table. The available
interpolation modes are linear and
logarithmic. If the linear mode is used
for both frequency and amplitude, a
, or
Limit 1
, or
Limit 1
Delete
, or
Limit 1
Chapter 2