Marker To Trace - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
CALCulate:MARKer Subsection
Turns the marker table on or off
Front Panel
Access:
Marker, Marker Table On Off

Marker to Trace

:CALCulate:MARKer[1]|2|3|4:TRACe <integer>
:CALCulate:MARKer[1]|2|3|4:TRACe?
Assigns the specified marker to the designated trace 1, 2, or 3.
Factory Preset
and *RST: 1
Range: 1 to 3
Front Panel
Access:
Marker, Marker Trace Auto 1 2 3
Marker to Trace Auto
:CALCulate:MARKer[1]|2|3|4:TRACe:AUTO OFF|ON|0|1
:CALCulate:MARKer[1]|2|3|4:TRACe:AUTO?
Turns on or off the automatic marker to trace function.
Factory Preset
and *RST:
AUTO ON
Front Panel
Access:
Marker, Marker Trace Auto 1 2 3
Continuous Signal Tracking Function
:CALCulate:MARKer[1]|2|3|4:TRCKing[:STATe] OFF|ON|0|1
:CALCulate:MARKer[1]|2|3|4:TRCKing[:STATe]?
Turns on or off marker signal tracking. It continuously puts the selected marker on
the highest displayed signal peak and moves it to the center frequency. This allows
you to keep a signal that is drifting in frequency, on the display.
Factory Preset
and *RST: Off
Remarks: When a measurement under the front panel MEASURE key is
started, this command is turned off. If this command is turned
on when any of the MEASURE key measurements are in
258 Chapter 5