Set External Mixer Bias On/Off - Agilent Technologies ESA Series User's/Programmer's Reference

Set External Mixer Bias On/Off

[:SENSe]:MIXer:BIAS:STATe OFF|ON|0|1
[:SENSe]:MIXer:BIAS:STATe?
This command activates an internal bias source for use with external mixers. This
command is available only with Option AYZ (External Mixing).
Factory Preset
and *RST:
Remarks:
NOTE Mixer Bias will be set to Off when transitioning from manual harmonic mode to
auto harmonic mode.
Front Panel
Access:
Set External Mixer LO Harmonic Value
[:SENSe]:MIXer:HARMonic <integer>
[:SENSe]:MIXer:HARMonic?
This command allows you to set the LO harmonic value for mixers other than the
HP/Agilent 11970-Series or 11974-Series Mixers. This is done after the mixer
harmonic configuration ( [:SENSe]:MIXer:HARMonic:AUTO
OFF|ON|0|1 ) is set to Off (manual). This command is available only with
Option AYZ (External Mixing).
Factory Preset
and *RST:
Range:
Remarks:
Chapter 5
Off
The bias signal is present on the center conductor of the IF Input
connector on the front panel. See related command
[:SENSe]:MIXer:BIAS <numeric> .
Input/Output (or Input), Input Mixer, Mixer Config, Mixer
Bias On Off
–8 (Band A, 26.5-40 GHz)
Any non-zero integer from –50 to 50, inclusive
The harmonic value with its associated sign is automatically
determined from the external mixer band selected. This is the
AUTO mode. For mixers other than the HP/Agilent
11970-Series or 11974-Series, an LO harmonic other than that
determined in the AUTO mode may be required. This is
achieved using this command and related command
[:SENSe]:MIXer:HARMonic:AUTO OFF|ON|0|1 .
Remote Command Reference
[SENSe]:MIXer Subsection
329