Questionable Status Calibration Condition And Event Enable Registers - Agilent Technologies ESA Series User's/Programmer's Reference

Status Registers
Use Status Registers to Determine the State of Analyzer Events and Conditions

Questionable Status Calibration Condition and Event Enable Registers

The Questionable Status Calibration condition register continuously monitors the calibration status of
the analyzer. Condition registers are read-only. To query the condition register, send the command
:STATus:QUEStionable:CALibration:CONDition? The response will be the decimal sum of
the bits which are set to 1.
226
Bit Decimal Description
Value
0 0 Oversweep (Meas Uncal): A 1 in this position indicates
that the analyzer is in a state that could lead to uncalibrated
measurements. This is typically caused by sweeping too fast
for the current combination of span, resolution bandwidth, and
video bandwidth. Auto coupling may resolve this problem.
1 2 Signal Ident ON: A 1 in this bit position indicates that
amplitude measurements may be in error due to signal
identification routines being active. Amplitude accuracy is
degraded when signal identification is active. (Agilent ESA
model E4407B Option AYZ, External Mixing, only.)
2 4 Reserved: This bit is not used by the analyzer, but is for
future use with other Agilent products.
3 8 Unused: This bit is always set to 0.
4 16 Unused: This bit is always set to 0.
5 32 Unused: This bit is always set to 0.
6 64 Unused: This bit is always set to 0.
7 128 Unused: This bit is always set to 0.
8 256 Unused: This bit is always set to 0.
9 512 Unused: This bit is always set to 0.
10 1024 Unused: This bit is always set to 0.
11 2048 Unused: This bit is always set to 0.
12 4096 Unused: This bit is always set to 0.
13 8192 Unused: This bit is always set to 0.
14 16384 Unused: This bit is always set to 0.
15 32768 Always Zero (0): This bit is always set to 0.
Chapter 4