Frequency Synthesis Mode - Agilent Technologies ESA Series User's/Programmer's Reference

Frequency Synthesis Mode

[:SENSe]:FREQuency:SYNThesis 1|2|3
[:SENSe]:FREQuency:SYNThesis?
This command switches between two phase noise optimization modes. Mode 2
optimizes the analyzer for close-in phase noise. Mode 3 optimizes the analyzer for
tuning speed. Mode 1 is not recommended for new designs.
This command is available for the following models only:
E4402B, E4403B, E4404B, E4405B, E4407B, E4408B
Factory Preset
and *RST: 3
History: Added with firmware revision A.08.00.
Front Panel
Access: AUTO COUPLE, PhNoise Opt
Frequency Synthesis State
[:SENSe]:FREQuency:SYNThesis:AUTO OFF|ON|0|1
[:SENSe]:FREQuency:SYNThesis:AUTO?
This command switches between auto and manual phase noise selection.
When in auto mode, the phase noise optimization is set as follows:
For spans ≤ 10 MHz, the analyzer is optimized for phase noise.
•
For spans > 10 MHz, the analyzer is optimized for fast tuning.
•
This command is available for the following models only:
E4402B, E4403B, E4404B, E4405B, E4407B, E4408B
Factory Preset
and *RST: On
History: Added with firmware revision A.08.00.
Front Panel
Access:
AUTO COUPLE, PhNoise Opt
Chapter 5
Remote Command Reference
[:SENSe]:FREQuency Subsection
327