View Of Emi Detection - Agilent Technologies ESA Series User's/Programmer's Reference

QPEak - The quasi peak detector weights the peak-detected amplitude using
specific charge, discharge, and meter time constants. The effect of this detector
depends on the characteristics and repetition rate of the input signal. When the
quasi-peak detector is selected, the analyzer is forced to linear amplitude
display using sample detection.
AVERage - The EMI average detector averages the peak detection amplitude.
When EMI average detection is selected, the analyzer is forced to linear
amplitude display using sample detection.
OFF - Turning EMI detectors off restores the amplitude reference level and
scale type (logarithmic or linear) that was used prior to the selection of either
the quasi-peak or average detector.
Factory Preset
and *RST: Off
Couplings/
Dependencies: When the EMI detector is Off, the
SENSe:DETector:FUNCtion:EMI:VIEW and
SENSe:POWer:QPGain:STATe functions are not available.
Remarks: This command is only available with Option AYQ installed.
History: Added with firmware revision A.14.00.
Front Panel
Access: Det/Demod
Det/Demod
Det/Demod
Det/Demod

View of EMI Detection

[:SENSe]:DETector[:FUNCtion]:EMI:VIEW POSitive|EMI
[:SENSe]:DETector[:FUNCtion]:EMI:VIEW?
Selects between positive peak detection and the EMI quasi-peak/average detection,
without changing the ranging which adjusts the reference level. This allows you to
use peak detection while maintaining the current EMI measurement settings/view.
Factory Preset
and *RST: Off
Couplings/
Dependencies: This function is not available unless you have selected
SENSe:DETector:FUNCtion:EMI QPEak or AVERage .
Remarks: This command is only available with Option AYQ installed.
History: Added with firmware revision A.14.00.
Chapter 5
Remote Command Reference
[:SENSe]:DETector Subsection
, EMI Detector
, ,
EMI Detector Quasi Peak
, EMI Detector , EMI Average
, EMI Detector , Off
321