Select Internal Or External Mixer - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
INPut Subsystem

Select Internal or External Mixer

:INPut:MIXer INTernal|EXTernal
:INPut:MIXer?
This command selects either the internal or external input mixer and is available
only with Option AYZ (External Mixing).
Refer also to commands in the [:SENSe]:MIXer subsection.
Factory Preset
and *RST:
History:
Remarks:
Front Panel
Access:
Select Mixer Type
:INPut:MIXer:TYPE PRESelected|UNPReselect
:INPut:MIXer:TYPE?
This command selects the type of mixer being used and is available only with
Option AYZ (External Mixing).
Refer also to commands in the [:SENSe]:MIXer subsection.
Factory Preset
and *RST:
History:
Remarks:
NOTE Preselected Mixer Type is not allowed when AUTO harmonic and Ext Mix Band
K, E, W, F, D, G, Y, or J is selected.
Front Panel
Access:
292
INTernal
This command is available with firmware revision A.03.00 and
later.
External mixing is not available when frequency scale type is
Log ( [:SENSe]:SWEep:SPACing LINear|LOGarithmic ).
Selecting the external input mixer activates all the keys in the
Input Mixer menu and changes the RF attenuation annotation
readout on the display to "Ext Mix."
Input/Output (or Input), Input Mixer Int Ext
UNPReselect
This command is available with firmware revision A.03.00 and
later.
Setting mixer type to Presel activates a tuning signal that is
routed to the PRESEL TUNE OUTPUT connector on the
analyzer rear panel. This signal drives the tune input of the
HP/Agilent 11974-Series Preselected Mixers at 1.5V/GHz. The
sweep rate in this mode is limited to 40 MHz/msec.
Input/Output (or Input), Input Mixer, Mixer Config, Mixer
Chapter 5