Agilent Technologies ESA Series User's/Programmer's Reference page 136

Front-Panel Key Reference
Source
Allows you to set the step size of the power level range of the tracking
Amptd Step
generator. The default setting is one vertical scale division when in a
Auto Man
logarithmic amplitude scale.
Key Access:
Offsets the displayed power of the tracking generator. Using the
Amptd Offset
amplitude offset capability of the tracking generator allows you to take
system losses or gains into account, thereby displaying the actual power
delivered to the device under test.
Key Access:
Key Access:
Normalize
Store Ref
(1 → 3)
Normalize
On Off
Segmented sweep is not available when
NOTE
Trace 1 should be in clear write mode prior to setting normalize to on.
CAUTION
136
Source
Source
Source
Copies trace 1 into trace 3.
pressed before pressing
Store Ref (1 → 3)
is pressed before
Store reference trace before turning on
Normalize is displayed in the status line, however
Normalize has been activated.
Key Access:
Source
Activates the normalize function. On
Normalize (On)
each sweep, the normalized trace (Trace 3) is
subtracted from Trace 1 and the result is added to the
normalized reference level. The display shows the
result of the following calculation:
Trace 1 – Normalized Trace + Normalized Reference
Level
The trace data is normalized with respect to the
normalized reference level, even if the value of the
normalized reference level is changed. This function
remains in effect on all subsequent sweeps until it is
turned off.
The normalize function is most useful for applying
correction data to a trace while making a stimulus
response measurement with a tracking generator. For
example, connect the cables and a thru line, in place of
the device to be measured, between the tracking
generator and the analyzer input. Notice that the
frequency response is not perfectly flat, showing the
Store Ref (1 → 3)
. If
Normalize (On)
, the error message:
, ,
More Normalize
is selected.
Normalize (On)
must be
Normalize (On)
Chapter 2