Agilent Technologies ESA Series User's/Programmer's Reference page 152

Front-Panel Key Reference
Sweep
when accessed by pressing the following front-panel keys:
BW/Avg
menu),
When the sweep trigger is set to any of the trigger selections other than
free run, no sweep occurs until the trigger condition is met. Once the
trigger occurs, all segments are swept, completing the entire trace.
For spectrum analyzers with Option 1DN or Option 1DQ, the tracking
NOTE
generator must be turned on (
the segmented sweep table.
The on/off state of the segmented sweep mode and the segmented sweep
table can be saved as a "state" type file (see
part of the power on/preset function (see
page
When loading a "state" type file, segmented sweep will not turn on if
NOTE
any of the parameters in the file contain optional instrument settings
not currently loaded on the analyzer or frequency settings outside the
current range of the analyzer.
Edit
152
( and
Resolution BW
(see above), and
Span
156).
Accesses the segmented sweep editor, where a
maximum of thirty-two segments can be defined by the
segment number and the six parameters described
below. Use the data control keys described in the
Agilent ESA Spectrum Analyzer Getting Started Guide
to enter the setting as each parameter is highlighted.
Refer to the "Editor" section above for more
information.
Key Access:
Segment
Center Freq
), (the entire softkey
Video BW Frequency
( and
Sweep Sweep Time
,
Source Amplitude (On)
"Save" on page
"Power On/Preset" on
, ,
Sweep Segmented Modify
Allows you to select a previously
defined segment or the next segment
for modification. Use the numeric
keypad to select a specific segment or
press the keys to access adjacent
Tab
segments.
Key Access:
Sweep, Segmented, Modify
Edit
Allows you to specify the center
frequency for a particular segment
using the data control keys. For more
information on this function, refer to
"Center Freq" on page
Key Access:
Sweep, Segmented, Modify
Edit
,
Auto Couple
).
Points
) before you set up
132) or as
,
98.
,
Chapter 2