Agilent Technologies ESA Series User's/Programmer's Reference page 123

Pressing the
Preset
• If
user preset state, change the analyzer settings as desired, then press
System
• If
factory defaults. Pressing
• If
described above.
Recalling any state, including the user preset state, will affect the
NOTE
conditions of more parameters than are affected by a factory preset. For
example, external preamp gain and input impedance correction are not
affected by a factory preset but may be affected by a user preset.
In the
NOTE
Factory
state of the analyzer (before it was turned off) is recalled if
set to
and
Table 2-2 Factory Preset Conditions
Amplitude correction factors
Amplitude Ref (Signal)
Amplitude units
Annotation and graticule
display
Attenuation
Center frequency:
E4401B and E4411B
E4402B and E4403B
E4404B
E4405B
E4407B and E4408B
CF step size
Coupled functions
Detector
Display line level
Chapter 2
front-panel key brings up the
Preset
, and menu keys.
Factory Preset
is pressed, the user preset state is recalled. To set the
User Preset
,
Power On/Preset
is pressed, the current mode settings are reset to the
Mode Preset
is pressed, a factory preset will be performed as
Factory Preset
menu, if
System Power On
, turning on the analyzer performs a factory preset. The last
. The user preset state is recalled if
Last
is set to
Preset Type User
, .
Save User Preset
does not change the mode.
Mode Preset
is set to , and
Preset
Power On
.
off
off
50 Ω input – dBm log
75 Ω input – dBmV log
on
10 dB (auto-coupled)
750 MHz
1.5 GHz
3.35 GHz
6.6 GHz
13.25 GHz
10% of span
all set to AUTO
Peak (auto-coupled)
–25 dBm, display off
Front-Panel Key Reference
Preset
,
User Preset Mode
is set to
Preset Type
is
Power On
is set to
Preset
123