Set Frequency Domain Scale Type - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
[:SENSe]:SWEep Subsection
When segmented sweep is turned on or off, all trace data (including stored trace
NOTE
data) is deleted.
This command applies to the following models having firmware revision A.05.00
NOTE
or later: E4401B, E4402B, E4404B, E4405B, E4407B.
Factory Preset
and *RST:
Remarks:
Front Panel
Access:

Set Frequency Domain Scale Type

[:SENSe]:SWEep:SPACing LINear|LOGarithmic
[:SENSe]:SWEep:SPACing?
Selects either linear or logarithmic for the frequency domain (X-axis) scale. The
trace query of comma-separated values maps frequency/amplitude pairs for the
mathematical interpolation of the log frequency axis. The value of
[:SENSe]:SWEep:POINts is adjusted to reflect the acquisition of data for the
given sweep span when log sweep spacing is enabled.
Factory Preset
and *RST:
Remarks:
340
Off
Segmented sweep will be turned off if any of the following
actions occur remotely or manually:
Factory Preset
Full Span is activated
Last Span is activated
On entering a measurement ( :MEASure subsystem
commands)
While segmented sweep is on, the following functions are
unavailable:
Auto couple
BW/Avg: RBW, VBW
Center/Start/Stop frequency, CF Step, and
frequency Offset
Span, sweep time, and points
Sweep, Segmented, ON/OFF
Linear
Refer to the User's Guide for detailed information on the
interactions of this command with other functions.
Chapter 5