Calibrate The Tracking Generator - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
CALibration Subsystem

Calibrate the Tracking Generator

:CALibration:TG
:CALibration:TG?
Performs an alignment of the tracking generator assembly.
The query performs the alignment and returns a zero if the alignment is successful.
NOTE This command is only applicable on Agilent ESA models E4402B, E4403B,
E4404B, E4405B, E4407B, and E4408B. Before executing this command, connect
a cable between front panel connector and the connector. The
RF OUT INPUT
alignment will fail using command CAL:TG if the cable is not connected.
Front Panel
Access:
System, Alignments, Align Now, TG
Chapter 5 269