Delete All Segmented Sweep Data - Agilent Technologies ESA Series User's/Programmer's Reference

Default Unit:

Delete All Segmented Sweep Data

[:SENSe]:SWEep:SEGMent:DELete
Deletes all segmented sweep data.
NOTE This command applies to the following models having firmware revision A.05.00
or later: E4401B, E4402B, E4404B, E4405B, E4407B.
Front Panel
Access:
Delete Some Segmented Sweep Data
[:SENSe]:SWEep:SEGMent:DELete:ROW <integer>
Deletes only the specified segmented sweep data (row).
NOTE This command applies to the following models having firmware revision A.05.00
or later: E4401B, E4402B, E4404B, E4405B, E4407B.
Range:
Front Panel
Access:
The front panel keys shown for this command deletes the active segment only. The
NOTE
remote command deletes any specified segment.
Turn On/Off Segmented Sweep
[:SENSe]:SWEep:SEGMent[:STATe] OFF|ON|0|1
[:SENSe]:SWEep:SEGMent[:STATe]?
Turns on or off segmented sweep. Segmented sweep is a mode where only bands
of interest are measured with the data presented in a single trace. This improves
measurement speed and provides more detail and resolution in those bands.
Chapter 5
Resolution Bandwidth: 1 kHz to 5 MHz
Video Bandwidth: 30 Hz to 3 MHz
Number of Points: 101 to 8192, 2 to 8192 in zero span. The total
number of points for all segments is ≤ 8192 .
Fundamental units (without entering the actual units)
Sweep, Segmented, Modify, Delete
1 to maximum number of segments
Sweep, Segmented, Modify, Edit, Delete Segment
Remote Command Reference
[:SENSe]:SWEep Subsection
339