Demod Time - Agilent Technologies ESA Series User's/Programmer's Reference

Remote Command Reference
[:SENSe]:DEMod Subsection

Demod Time

[:SENSe]:DEMod:TIME <time>
[:SENSe]:DEMod:TIME?
Sets the time used for frequency domain demodulation.
Factory Preset
and *RST: 500 ms
Range: 2 ms to 100 s
Default Unit: seconds
Front Panel
Access: Det/Demod, Demod, Demod Time
Demod View
[:SENSe]:DEMod:VIEW[:STATe] OFF|ON|0|1
[:SENSe]:DEMod:VIEW[:STATe]?
This command is only available if FM demodulation is selected. It causes the
demodulated signal to be displayed with the y-axis scale in units of kHz. Use
:DISPlay:WINDow:TRACe:Y:SCALe:PDIVision:FREQuency to set
scale/div.
If FM Demod is on, then several functions are not available. These include:
Log/Lin (display is always in linear), Y-Axis Units, Marker Search functions,
Normalize, Display Line, Peak Excursion, and Peak Threshold. These functions
are not affected when AM demodulation is selected.
Factory Preset
and *RST: Off
Remarks: This command is not available when Demod is set to Off.
History: Added with firmware revision A.14.00.
Front Panel
Access: Det/Demod, Demod, FM, Demod View
318 Chapter 5