Table of Contents
Advertisement
The Graphical User Interface
Agilent 81950A Compact TLS module, First Edition
How to set Frequency Parameters in Grid
Mode
In "Grid Mode" (i.e. "Auto Mode off") the main parameter (i.e. the
parameter shown in the topmost line) is the channel number [Ch].
The resulting output frequency must be set using the reference frequency,
grid spacing, frequency offset, and channel number.
• Move to the parameter you want to change (it may be necessary to open
the menu by pressing the [Menu] soft key to access it).
• Change the value as described in chapter "How to Set a Parameter" on
page 37.
Reference frequency and grid spacing can only be changed if the laser is
N O T E
off.
Operating Instructions
45
Advertisement
Table of Contents
