To Set Power Line Frequency - Agilent Technologies 4339B User Manual

To Set Power LINE Frequency

1. Connect the power cable to the power cord receptacle on the rear panel.
2. Push the LINE switch in. The 4339B will emit a beep and perform the self test. (If any
message is displayed, see \Error Messages" back of
will be ready for operation after a message like the following is displayed.
3. Press . The following menu is displayed.
4. Press until
more
5. Press until
Line
A blinking item means that it is currently selected.
6. If the setting does not match the power LINE frequency, press
between and
50Hz
7. Select and press
Exit
The power line frequency setting is stored and is not changed after reset or
Note
power-o . Once you set it, you do not need to set the line frequency again as
long as the same power line frequency is being used.
1-2 Preparation for Use
blinks, and press
blinks, and press
, then press
60Hz
to exit this menu.
4339B Operation Manual
.
.
.
4339B
.) The 4339B
to toggle the setting