Show Bgp Reflection {[Ipv4 | Ipv6] Unicast - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Hold Time
Keepalive Interval
Always Compare MED
Deterministics MED
Med Confed
Default Local Preference
AS Path Ignore
Compare Router ID
MED Missing as Worst
Compare Confederation Path
Fast External Fallover
Aggregate Next Hop Check
BGP Trap
DGS-3620-28PC:admin#
Command: show bgp summary
BGP Router Identifier
local AS number
Dampening
BGP AS Path Entries
BGP Community Entries
Neighbor Ver
----------- ---
10.100.1.1 4
10.200.1.1 4
10.200.1.5 4
Total Number of Neighbors:3
DGS-3620-28PC:admin#
12-49 show bgp reflection
Description
This command is used to display the route reflection configuration of BGP. If both the IPv4 unicast
and IPv6 unicast are not specified, the reflection information for the IPv4 unicast will be displayed.
Format

show bgp reflection {[ipv4 | ipv6] unicast}

Parameters
ipv4 unicast - Specifies to display reflection information for IPv4 unicast.
ipv6 unicast - Specifies to display reflection information for IPv6 unicast.
Restrictions
None. (EI Mode Only Command)
: 300 Seconds
: 100 Seconds
: Disabled
: Disabled
: Disabled
: 200
: Disabled
: Enabled
: Disabled
: Disabled
: Enabled
: Disabled
: None
show bgp summary
: 172.16.1.1
: 100
: Enabled
: 10
: 7
AS MsgRcvd MsgSent
-- ------- -------
200 26 22
300 21 51
300 21 5
217
Up/Down State/PfxRcvd
------- -------------
00:14:23 23
00:13:40 0
00:10:05 Idle