Authentication Source Ip Interface Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Encryption
Old Local Enable
Password
New Local Enable
Password
Confirm Local Enable
Password
Local Enable
Password
Click the Apply button to accept the changes made.

Authentication Source IP Interface Settings

This window is used to specify source interface for all outgoing RADIUS and TACACS packets.
To view this window, click Security > Access Authentication Control > Authentication Source IP Interface
Settings as shown below:
Figure 9-78 Local Enable Password Settings window
Description
Specifies the encryption type to be used for the password.
Plain Text - Specifies that the password entered should be in plain text form.
SHA1 - Specifies that the password entered should be in SHA-1 encrypted form.
If a password was previously configured for this entry, enter it here in order to change
it to a new password
Enter the new password that you wish to set on the Switch to authenticate users
attempting to access Administrator Level privileges on the Switch. The user may set a
password of up to 15 characters.
Confirm the new password entered above. Entering a different password here from
the one set in the New Local Enabled field will result in a fail message.
After selecting one of the Encryption options, the user can enter the local password
used here.
Figure 9-79 Authentication Source IP Interface window
489