Rep 28.2 Outbin Assembly - Xerox Phaser 3635MFP Service Manual

REP 28.2 Outbin Assembly

Parts List on PL 28.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to
1. Remove the DADF, PL 5.10 Item 1.
2. 3635 only. Remove the UI assembly,
3550 only. Remove the UI assembly,
3. Remove the left cover, right cover and rear cover,
4. Remove the scanner assembly, REP
5. 3550 only. Remove the stapler assembly,
6. 3635 only. Disconnect the following harnesses from the
• CN1
• CN2
• CN6
• CN7
• CN8
3550 only. Disconnect the following harnesses from the
• CN1
• CN3
• CN4
• CN5
• CN6
7. 3635 only. Disconnect the following harnesses from the
• CN2
• CN7
• CN14
• CN15
• CN26
3550 only. Disconnect the following harnesses from the
• CN12
• CN14
8. Remove the exit cover assembly, PL 28.10 Item
Repairs and Adjustments
REP 28.2
CAUTION
GP 10 General Disassembly Precautions.
REP 2.1.
REP 2.3.
REP 28.1.
14.1.
PL 11.10 Item 4.
Connection PWB:
Connection PWB:
Main PWB:
Main PWB:
2.
9. Prepare to remove the outbin assembly,
Main PWB location spigot
Take care not to damage the main PWB location spigot when removing the outbin, refer to
ure 1. Also, take care not to move the exit roll and idlers.
April 2010
4-42
Figure 1.
1
Remove 4 screws marked A.
Figure 1 Preparation
CAUTION
Phaser 3635MFP/WorkCentre 3550
Fig-