Table of Contents
Advertisement
2
3
a
b
1
c
a
c
d
c
a
c
a
b
d
2, 3
2
1
3
RADIATOR AND CONDENSER COOLING FAN
Refer to "RADIATOR AND CONDENSER COOLING FAN" in
Section 1B for removal, inspection and installation.
RADIATOR AND CONDENSER COOLING FAN
RELAY
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Remove radiator and condenser cooling fan relay No.1 (1),
No.2 (2) and No.3 (3) from vehicle.
3) Check that there is no continuity between terminal "c" and
1
"b". If there is continuity, replace relay.
4) Connect battery positive (+) terminal to terminal "b" of relay.
Connect battery negative (–) terminal "a" of relay.
Check continuity between terminal "c" and "d".
If there is no continuity when relay is connected to the bat-
tery, replace relay.
d
b
d
b
WATER PUMP/GENERATOR DRIVE BELT
REMOVAL
1) Disconnect negative cable at battery.
2) Loosen drive belt adjusting bolt (2) and generator pivot bolt
(3).
When servicing car equipped with A/C, remove compressor
drive belt (4) before removing water pump belt (1).
Refer to "COMPRESSOR DRIVE BELT" in Section 1B.
4
3) Slacken belt by displacing generator and then remove it.
ENGINE COOLING 6B-15
Advertisement
Table of Contents
