Subaru Legacy 2002 Service Manual page 3036

18. Ignition Key Lock
A: REPLACEMENT
1) Disconnect ground cable from battery.
2) Remove the steering column. <Ref. to PS-24,
REMOVAL, Tilt Steering Column.>
3) Secure the steering column in a vise. Remove
the bolt with a drill.
4) Remove the ignition key lock.
5) Use a new torn bolt. Tighten the torn bolt to the
end of the thread.
B: INSPECTION
1) Remove the instrument panel lower cover.
2) Remove the lower column cover.
3) Unfasten the hold-down clip which secures the
harness and disconnect the connector of the igni-
tion switch from the body harness.
4) Turn the ignition key plate to each position and
check the continuity between the terminals of the
ignition connector.
Switch position Terminal No.
LOCK
ACC No. 1 and No. 2
ON No. 1 and No. 2
No. 1 and No. 4
No. 2 and No. 4
ST No. 1 and No. 3
No. 1 and No. 4
No. 3 and No. 4
If NG, replace the ignition switch.
IGNITION KEY LOCK
S909318
S909318A20
B5M1061
S6M0162A
S909318A10
Standard
— —
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω
SL-33
Security and Locks