Subaru Legacy 2002 Service Manual page 3138

4. Cruise Control Main Switch
S912498
A: REMOVAL
S912498A18
1) Disconnect ground cable from battery.
2) Remove screws and clip from instrument panel
lower cover.
3) Remove front cover (A) while disconnecting
connector.
4) Remove two screws (B) and then remove cen-
ter panel (C) while disconnecting connector.
5) Remove fitting screws, and slightly pull radio
and switch assembly out from center console.
6) Disconnect electric connectors and antenna
feeder cord and then disconnect heater control
unit.
7) Remove screw and detach the bracket and
then remove switch panel.
CRUISE CONTROL MAIN SWITCH
B6M1209A
B6M1210
B6M1565
CC-7
8) Remove main switch by pushing it outward.
B: INSTALLATION
Install is in the reverse order of removal.
C: INSPECTION
Switch position Terminal No.
OFF 3 and 5
ON 3 and 5
If NG, replace cruise control main switch.
Cruise Control System
B6M1566
S912498A11
S912498A10
G6M0244
Standard
More than 1 MΩ
Less than 1 Ω