Subaru Legacy 2002 Service Manual page 3081

Exterior/Interior Trim
B: INSTALLATION
1) Apply primer to original side protector (if used),
and attach two-sided tape to side protectors as
shown.
Two-sided tape:
Thickness; 1.2 mm (0.047 in)
Width; 5 mm (0.20 in)
Recommended primer:
SUMITOMO 3MK-500 or equivalent
Recommended two-sided tape:
SUMITOMO 3M5305 or equivalent
2) Using an infrared lamp, heat body panel to 40
to 60°C (104 to 140°F) and rear surface of side
protector to 20 to 30°C (68 to 86°F).
3) Remove tack paper from two-sided paper.
While aligning clips with holes in body panel,
attach two-sided tape to side protector and body
panel with a force of more than 49 N (5 kgf, 11 lb)
with roller. Do not allow air to enter mating surface
of the two.
CAUTION:
¼ To maintain adhesive power, do not wash the
vehicle for 24 hours after tape application.
¼ Push clip in securely using hands.
(To prevent deformation, do not use excessive
force.)
PROTECTOR
S911380A11
B5M0303A
EI-26