Subaru Legacy 2002 Service Manual page 3090

16. Instrument Panel Assembly
S911381
A: REMOVAL
S911381A18
Airbag system wiring harness is routed near the
combination meter.
WARNING:
¼ All airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
¼ Be careful not to damage airbag system har-
ness when servicing the instrument panel.
NOTE:
The following location are for LHD model.
The locations for RHD model are symmetrically
opposite.
1) Disconnect ground cable from battery.
2) Remove lower cover.
3) Remove lower column cover and disconnect
harness connectors to steering column.
4) Remove steering column assembly (with steer-
ing wheel). <Ref. to PS-24, REMOVAL, Tilt Steer-
ing Column.>
INSTRUMENT PANEL ASSEMBLY
B5M0639A
B6M1184
EI-35
5) Remove stopper (A) then remove glove box.
6) Remove side panel of both sides.
7) Remove passenger's airbag module. <Ref. to
AB-13, REMOVAL, Passenger's Airbag Module.>
8) Remove console
REMOVAL, Console Box.>
9) Remove front pillar upper trim of both sides.
Exterior/Interior Trim
B5M0640A
B5M0641A
box. <Ref. to EI-34,
B5M0644A