Rear Door Panel - Subaru Legacy 2002 Service Manual

6. Rear Door Panel

A: REMOVAL
S913364A18
1) Disconnect ground cable from battery.
2) Remove rear door trim. <Ref. to EI-31,
REMOVAL, Rear Door Trim.>
3) Remove rear door regulator and motor assem-
bly. <Ref. to GW-19, REMOVAL, Rear Regulator
and Motor Assembly.>
4) Remove rear outer handle. <Ref. to SL-24,
REMOVAL, Rear Outer Handle.>
5) Remove center pillar lower trim. <Ref. to EI-41,
REMOVAL, Lower Inner Trim.>
6) Remove seatbelt bracket and blind plug.
Disconnect connector of door harness and remove
door hinge nut.
7) Put a wooden block on the jack and place the
jack under the door. Support the door with the jack
to protect it.
8) Remove checker bolts.
REAR DOOR PANEL
S913364
B5M1062
S5M0183
EB-15
9) Remove door-side bolts for upper and lower
hinges to remove door.
10) Using special tool, remove body-side bolts for
upper and lower hinges, and remove door hinges.
CAUTION:
¼ During removal and installation of doors, do
not damage body.
¼ Doors are heavy. Be careful not to drop and
damage them.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to sliding area of door hinges.
Tightening torque:
Refer to COMPONENT in General
Description. <Ref. to EB-5, REAR DOOR
PANEL, COMPONENT, General Descrip-
tion.>
Exterior Body Panels
G5M0385
S913364A11