Front Bumper - Subaru Legacy 2002 Service Manual

Exterior/Interior Trim

4. Front Bumper

A: REMOVAL
S911371A18
CAUTION:
¼ Handle bumper carefully to avoid damage to
bumper face.
¼ Do not damage body during removal or
installation of bumper.
¼ To avoid damage to bumper, lay removed
bumper on sheet spread on the floor. Do not lay
it directly on the floor.
1) Open hood.
2) Disconnect ground cable from battery.
3) Pull off front side of front mat guard to remove
bolts.
4) Remove clip at bottom of bumper.
5) Remove clip (A), and pull out bumper slightly.
6) Disconnect electrical connector of fog light to
remove bumper.
FRONT BUMPER
S911371
B5M0754
B5M0994
B5M0738A
EI-14
7) Remove bumper beam.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
¼ Handle bumper carefully to avoid damage to
bumper face.
¼ Do not damage body during removal or
installation of bumper.
Tightening torque:
Refer to COMPONENT in General
Description. <Ref. to EI-2, FRONT
BUMPER, COMPONENT, General Descrip-
tion.>
B5M0756
S911371A11