Station Relocation - NEC UNIVERGE SV9100 Features And Specifications

Station Relocation

Description
Station Relocation allows a station to be moved (swapped) from one location to another, without having
to reprogram the station data. The station features and extension number are the same after it is moved
to the new location.
Refer to the Programming section in this feature for system programs that are swapped.
Conditions
This feature can be used to swap or relocate multiline and single line terminals.
This feature is not supported for IP terminals (Softphone or a physical IP phone).
The destination extension must be idle. If the station is not idle, error tone is heard.
If the Extension Swap service code is dialed from an extension that does not have an
extension swap password programmed, error tone is heard.
If the Extension Swap service code is dialed from an extension whose Class of Service
does not allow Extension Data Swap, error tone is heard.
If the destination extension entered is not a valid extension, error tone is heard.
The following user setting data is relocated with the extension. All other user setting data is
either not relocated or cleared.
DND
Call Forwarding
Memo Dial
Last Number Dial History
Saved Number Dial
Incoming History
MIC LED Status
VM MW LED Status
When using Set Relocation, and a terminal is re-located from one physical system to
another physical system, route programming must be made accordingly for 911 calls.
Default Settings
None
System Availability
Terminals
All Multiline Terminals and Single Line Telephones
1152