NEC UNIVERGE SV9100 Features And Specifications page 1226


Meet Me Paging Transfer

One-Touch Calling

Serial Call
Guide to Feature Programming
Program
Program Name/Description
Number
Service Code Setup (for Service Access) –
11-12-58
Transfer into Conference
Assign the code a user dials to Transfer a call
into a Conference call. This code is normally
624.
11-15-09 Service Code Setup Administrative (for
Special Access) – Transfer to Incoming Ring
Group
When a call is transferred using this service
code, it is transferred to the ring group
destination for that incoming trunk. For
example, trunk 2 is in Ring Group 4. When the
call is transferred using this service code, the
trunk rings all extensions programmed for Ring
Group 4 or ring the External Paging Group for
Ring Group 4, depending on how the system is
programmed.
Multiline Telephone Basic Data Setup –
15-02-05
Transfer Key Operation Mode
Set the operating mode of the extension Conf
key. The keys can be for Call Transfer, Serial
Calling or Flash. When selecting 2, refer also to
Program 81-01-14.
Multiline Telephone Basic Data Setup –
15-02-24
Conference Key Mode
Program an extension Conf key for Conference
or Transfer. When set for Transfer, the user
places a call on hold, dials the extension to
which it should be transferred, then presses
Conf. The call is then transferred. When set for
Conference, with an active call, the user can
press Conf, place a second call, then press
Conf twice. All the calls are then connected.
15-07-01 Programmable Function Keys
Extension users may want a function keys
programmed for Transfer (code 06).
System Options for Multiline Telephones –
20-02-04
Retrieve the Line After Transfer
Enable/Disable an extension user ability to
answer a call after it is transferred, but before it
is answered.
Input Data
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
0 = Transfer
1 = Serial Call
2 = Flash
0 = Conference
1 = Transfer
Line Key 1 ~ 48
0 ~ 99 (Normal Function Code
851 by default)
* *
00 ~ 99 (Appearance
Function Code) (Service Code
852 by default)
0 = Not Holding (No Keep)
1 = Holding (Keep)
1226
Default
No Setting
No Setting
0
0
1