Automatic Tandem Trunking Using Speed Dialing - NEC UNIVERGE SV9100 Features And Specifications

Single Line Telephone:
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press hookflash.
3. Place or answer second trunk call.
4. To set up the tandem call, hang up.
 This sets up a Conference between both outside parties.
 To disconnect the Conference, use Forced Trunk Disconnect [i.e., Dial the trunk access code (
trunk number) +
Method D – Automatic Tandem Trunking Using Speed Dialing
To set Automatic Tandem Trunking:
1. Dial service code 833 (or the service code set for Set Automatic Transfer per Trunk).
2. Dial the desired trunk number (Trunk Number: 001~400).
3. Hang up.
 The line key for the trunk is solid red as long as the Unsupervised Conference continues.

To disconnect the Conference, use
number + 3).
*
To cancel Automatic Tandem Trunking:
1. Dial service code 834 (or the service code set for Disable Automatic Transfer per Trunk).
2. Dial the desired trunk number (Trunk Number: 001~400).
3. Hang up.
 To disconnect the Conference, Forced Trunk Disconnect (i.e., Press the line key or
number + 3 or the service code set of Forced Trunk Disconnect in Program 11-10-26).
*
To set and change the destination of the Automatic Tandem Trunk call:
1. Dial service code 835 (or the service code set for Set Destination for Automatic Trunk-to-Trunk
Transfer).
2. Dial the desired trunk number (Trunk Number: 001~400).
3. Dial the desired time mode (Time Mode: 1~8).
4. Dial the destination Number (trunk access code is not needed).
5. Press Hold.
6. Hang up.

To disconnect the Conference, use
number + 3).
*
3 or the service code set of Forced Trunk Disconnect in Program 11-10-26].
*
Forced Trunk Disconnect (i.e., Press the line key or
Forced Trunk Disconnect (i.e., Press the line key or
1210
# 9 +
# 9 plus the trunk
9 plus the trunk
#
# 9 plus the trunk