NEC UNIVERGE SV9100 Features And Specifications page 1159

Hide thumbs Also See for UNIVERGE SV9100:

Table of Contents

When network communication is down, an alarm is sent to the Attendant terminal informing of

the communication error on the network. Improvements also allow for a defined number of

network outages per clock hour before failing over.

When the Attendant telephone exists on a secondary system, alarm information is not

displayed on the Attendant telephone.

When Fail Over occurs between the Primary System and two or more Secondary Systems,

the Attendant telephone displays the System ID of the system that went into Fail-Over last.

When using InMail in a CCIS or Netlink network, 8-digit extensions and mailboxes are not

The SV9100 can recognize each system where the DT700 extension(s) are connected and

provide an Automatic Route Selection (ARS) COS based on the System (System ID) when

using NetLink.

When NetLink is enabled, synchronous ringing (Program 14-02-17) is automatically

disabled. Synchronous ringing is not supported in a NetLink environment.

All nodes in a NetLink network should have the same setting in Program 51-01-04.

Restrictions

Netlink is only supported between SV9100 systems.

Netlink is not supported between SV8100 and SV9100 systems.

The number of total ports depends on the Primary System.

System ID (Program 51-01-02) must be unique for each system in a NetLink network.

MIS can connect to the Primary (Main) site only.

Only one Voice Mail can be installed in a NetLink network.

In-Mail and VRS use the VMDB of the Primary (Main) site.

APSU can be installed in the Secondary (Remote) System, however the NetLink time zone

follows the Primary (Main) System.

Secondary systems must follow the primary CPU software settings for Mu-law/A-law within

CPU Reset Programs

When Changed Using

Handset, WebPro, PCPro

WebPro, Handset Programming

Handset, WebPro, PCPro

Handset Programming

Handset, WebPro, PCPro