NEC UNIVERGE SV9100 Features And Specifications page 1170

Program
Program Name/Description
Number
51-17-01 NetLink DT800/DT700 Server Individual
Information Setup – Registrar Port
Use to set the SIP Register Port of each
system.
51-17-02 NetLink DT800/DT700 Server Individual
Information Setup – Subscribe Session Port
Use to set the SIP Subscribe Session Port
number of each system when NetLink is used.
Netlink Configuration Options – Netlink Fail-
51-18-01
Over Limit
When tear-down of network was repeated more
than the specified times, NetLink is operated
stand-alone.
51-19-01 NetLink IP Trunk (SIP) Calling Party Number
Setup for Extension – NetLink CPN
Transmission
This program assigns transmission of Calling
Party Number (CPN) from Program 21-19 for
each secondary system. The transmission
applies for every extension.
IPL Basic Setup – IP Address
84-26-01
Assign the IP address for each DSP on the
GPZ-IPLE.
IPL Basic Setup – RTP Port Number
84-26-02
Assign the RTP port number to be used for
each DSP on the GPZ-IPLE.
Only even numbered ports are supported.
IPL Basic Setup – RTCP Port Number (RTP
84-26-03
Port Number +1)
Assign the RTCP Port number to used for each
DSP on the GPZ-IPLE.
Operation
None
Input Data
0 ~ 65535
0 ~ 65535
0, 2 ~ 10
(0 = Infinity)
0 = Disable
1 = Enable
xxx.xxx.xxx.xxx
0 ~ 65534
0 ~ 65534
1170
Default
5080
5081
0
1
Slot 1 =
172.16.0.20
VoIP GW1 =
10020
VoIP GW1 =
10021