NEC UNIVERGE SV9100 Features And Specifications page 1205

Program
Program Name/Description
Number
Speed Dialing Number and Name – Transfer
13-04-04
Destination Number
Store transfer destination number data in the
Speed Dialing areas.
Speed Dialing Number and Name –
13-04-05
Incoming Ring Pattern
Store incoming ring pattern data in the Speed
Dialing areas.
Basic Trunk Data Setup – Transmit Gain
14-01-04
Level for Conference and Transfer Calls
Select the Transmit CODEC gain level used by
the trunk when it is part of an Unsupervised
Conference.
Basic Trunk Data Setup – Receive Gain
14-01-05
Level for Conference and Transfer Calls
Select the Receive CODEC gain level used by
the trunk when it is part of an Unsupervised
Conference.
Basic Trunk Data Setup – Trunk-to-Trunk
14-01-13
Transfer
For each trunk, enter 1 to enable loop
supervision.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to an
extension.
20-07-05 Class of Service Options (Administrator
Level) – Set/Cancel Automatic
Trunk-to-Trunk Transfer
Turn Off or On an extension user ability to use
the Trunk-to-Trunk Forwarding service codes.
20-07-11 Class of Service Options (Administrator
Level) – Forced Trunk Disconnect (analog
trunk only)
Turn Off or On an extension user ability to use
Forced Trunk Disconnect. This allows the
extension user to disconnect an Unsupervised
Conference in progress.
Input Data
Maximum of 24 characters
If Transfer mode is (Refer to
13-04-03):
1 = Internal Dial Mode
#
1 ~ 9, 0, *, , P, R, @
2 = Incoming Ring Group
0 ~ 100 (IRG Number)
P = Pause R = Recall
@ = Additional Digits when
using ISDN functionality
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern (1 ~ 4)
5 ~ 9 = Scale Pattern (1 ~ 5)
10 ~ 13 = Tone Pattern (5 ~ 8)
1 ~ 57 (-15.5dB ~ +12.5dB in
0.5dB intervals)
1 ~ 57 (-15.5dB ~ +12.5dB in
0.5dB intervals)
0 = Disable
1 = Enable
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
0 = Off
1 = On
0 = Off
1 = On
COS 1~14 = 0
COS 15 = 1
1205
Default
No Setting
0
32 (0dB)
16 (-8dB)
1
Extension port
101 = Class 15
All other
extension port =
Class 1
COS 1 ~ 15 = 0
COS 1~14 = 0
COS 15 = 1