Table of Contents
Advertisement
third party transceivers. Cross-connect
the transmit channel at each end to the
receive channel at the opposite end as
illustrated in the figure.
LED INDICATORS
You can also view the LEDs for the ES7510-XT through the web interface
using the Device Front Panel page.
LEDs
LED Lit
Sys
System is ready
Power 1/2
Power is on
RS (Ring
Green: Ring is normal
Status)
Amber: Abnormal Ring
DO (Red)
Relay is active and
contacts have been
shorted
DI (Green)
High digital signal is
detected
LINK/ACT
Port is linked
1000M
Port is linked at
1000Mbps
PoE
PoE is applying power
PROGRAMMING THE IP ADDRESS
Configure the IP address using one of the following methods:
•
PortVision DX can be downloaded from http://downloads.comtrol.com/
rocketlinx/portvision_dx
•
Web browser
•
Telnet
LED Blinking
Firmware is uploading
Not applicable
Green: Ring with the
wrong port
Amber: The device's ring
port failed
Not applicable
Not applicable
Port active
Not applicable
Detecting
5
TX
TX
RX
RX
A
LED Off
System not ready
Power is not applied
Switch working in slave
mode
DO not activated
DI not activated
Port link down or port not
connected
Not applicable
PoE disabled: power out-
put over current, a cable
short, or PoE is disabled
for that port
B
Advertisement
Table of Contents
