3.5.3.6.4
CALCulate2:TRANsform:HISTogram:DATA query
Only bin data is reads out from numerical data of histogram display.
This command cannot be used with multi command.
Query syntax
:CALCulate2:TRANsform:HISTogram:DATA?
Response message <histogram_data_block>
<histogram_data_block> becomes the format of which the following data is punctuated by comma
(,).
Smaller number of measured data than range lower limit value
Number of data of each bin
Larger number of measured data than range upper limit value
In case the range information is required, use :CALCulate2:TRANsform:HISTogram:ALL?
3.5.3.6.5
CALCulate2:TRANsform:HISTogram:POINts command/query
This sets and reads out number of bin of the histogram display.
Command syntax
:CALCulate2:TRANsform:HISTogram:POINts {<point>|MIN|MAX|DEF}
<point>
<Numerical program data>
2, 4, 5, 10, 20, 40, 50, 100, 200, 400
Numerical value beyond limit is set by rounding up maximum value/minimum value within range,
and becomes execution error.
The numerical number other than specified one is set by rounding up in higher side number of the
specified numerical number, and does not become execution error.
Query syntax
:CALCulate2:TRANsform:HISTogram:POINts? [{MIN|MAX}]
Response message <point>
<point>is <NR1 numerical response data> format figures.
Default value
20
73