3.7.3 SUB-related commands
The following describes commands starting with the header :SUB .
The command syntax after the header is the same as MAIN-related command.
They set/control the dual-display function of the VOAC752x series.
Since this instrument does not include the function corresponding to the dual-display of the
VOAC752x series, all SUB-related commands result in the execution error.
3.7.4 Measurement function-related commands
They are the commands with the measurement functions whose headers are shown in the table
below.
The command syntac after the header is the same as the MAIN-related commands.
The command for the control system is not supported.
They set/read out the measurement function specified by the header.
Header
:DCV
:ACV
:DCA (or :DCI)
:ACA (or :ACI)
:OHM (or :RES)
:O4W (or :FRES)
:CONT
:TEMP
:FREQ
:DIOD
:BCH
:DAV
:DAA
:LOHM
*1 It is effective only for VOAC7602. It becomes an command error for VOAC7502.
2 Since they are not included in this instrument, the execution error occurs.
3.7.5 DUAL-relate commands
The following describes the commands starting with the header :DUAL.
They set/control the dual-display function for the VOAC752x series.
Since this instrument does not include the function corresponding to the dual-display of the
VOAC752x series, all DUAL-related commands result in the execution error.
The corresponding commands are
Syntax
:DUAL
Dual-display related
:DATA?
Acquisition of the latest measurement result for MAIN/SUB
:MEAS?
Acquisition of trigger synchronization measurement result for MAIN/SUB
:STAT[?]
Setting/reading of ON/OFF
:CALC[?]
Setting/reading of calculation between channels
Measurement function
DC voltage measurement
AC voltage measurement
DC current measurement
AC current measurement
2-teminal resistance measurement
4-teminal resistance measurement
Continuity measurement
Temperature measurement
Frequency measurement
Diode measurement
CH-B DC voltage measurement
(DC + AC) voltage measurement
(DC + AC) current measurement
Low power resistance measurement
Functions
212
*
1
2
2
2
2
Remarks
Execution error for all