Calculate2:Transform:histogram Subsystem; Calculate2:Transform:histogram:clear Command; Calculate2: Transform: Histogram:count Query; Calculate2:Transform:histogram:all Query - Iwatsu VOAC760 Manual

3.5.3.6

CALCulate2:TRANsform:HISTogram subsystem

3.5.3.6.1

CALCulate2:TRANsform:HISTogram:CLEar command

The histogram data is initialized.
Command syntax
:CALCulate2:TRANsform:HISTogram:CLEar
3.5.3.6.2

CALCulate2: TRANsform: HISTogram:COUNt query

It reads the sample counts included in the histogram data.
Query s yntax
:CALCulate2:TRANsform:HISTogram:COUNt?
Response message <count>
<count> is <NR1 numeric value response data> form at.
3.5.3.6.3

CALCulate2:TRANsform:HISTogram:ALL query

Numerical data of histogram display including range information is read out.
This command cannot be used with multi command.
Query syntax
:CALCulate2:TRANsform:HISTogram:ALL?
Response message <histogram_all_block>
<histogram_all_block> becomes the format of which the following data is punctuated by comma
( , ).
Range lower limit value
Range upper limit value
Total number of data
Smaller number of measured data than range lower limit value
Number of data of each bin
Larger number of measured data than range upper limit value
72